Troubleshooting Guide

Signs Your Bond Is Too Hard

The tooling runs cool but removal slows down and the scratch pattern looks shiny. This page outlines the likely causes, practical fixes, and a tooling path you can test on the next pass.

Problem Description

The tooling runs cool but removal slows down and the scratch pattern looks shiny.

Root Cause Analysis

  • The slab hardness is above the bond range.
  • Machine weight is not enough to expose fresh diamonds.
  • The grit is too fine for the first cut.

Solution Plan

  • Move one bond level softer.
  • Add weight or reduce travel speed on the opening pass.
  • Restart with a coarser grit before refining.

Recommended Product Direction

Soft-bond segments with open spacing.

Get this tooling set →Open Bond Selector

FAQ

What is the fastest first check for signs your bond is too hard?

Start by confirming floor hardness, opening grit, and whether the current bond is exposing fresh diamonds at the right pace.

When should I change tooling instead of machine settings?

If the scratch pattern stays inconsistent after a slower test pass and tool dressing, the bond or grit choice should change before production continues.

How do I get a recommendation for this issue?

Share the machine brand, floor hardness, and the symptom you see. We can suggest a better bond and grit sequence before the next pass.