Troubleshooting Guide

Best Tooling for Epoxy Coating Removal

Epoxy removal stalls when the segment packs up or smears heat across the slab. This page outlines the likely causes, practical fixes, and a tooling path you can test on the next pass.

Problem Description

Epoxy removal stalls when the segment packs up or smears heat across the slab.

Root Cause Analysis

  • Grit is too fine to break the coating.
  • Bond is too soft and smears resin into the segment face.
  • Travel speed is too slow for the coating thickness.

Solution Plan

  • Open with #16 or #30 grit for the first pass.
  • Use a stable medium bond unless the slab is extremely hard.
  • Keep the machine moving and vacuum dust continuously.

Recommended Product Direction

Coating-removal segment sets with open channels.

Get this tooling set →Open Bond Selector

FAQ

What is the fastest first check for best tooling for epoxy coating removal?

Start by confirming floor hardness, opening grit, and whether the current bond is exposing fresh diamonds at the right pace.

When should I change tooling instead of machine settings?

If the scratch pattern stays inconsistent after a slower test pass and tool dressing, the bond or grit choice should change before production continues.

How do I get a recommendation for this issue?

Share the machine brand, floor hardness, and the symptom you see. We can suggest a better bond and grit sequence before the next pass.